Modify Selection
- Hazard prevention and control:
- Noise and vibration control
- or
- Noise shielding
- or
- Vibration absorption
- or
- Noise damping
- or
- Vibration damping
- or
- Noise cancellation
- or
- Noise absorption
- or
- Mechanical isolation
Home Links
Results 51 - 60 of 78
-
2/1/2008 - Peer reviewed journal articlesThis paper describes the quiet-by-design approach of a noise control that reduced exposures of continuous mining machine operators by 3dB(A) using the four functional areas of Prevention through Design - Practice, Policy, Research, and Education.
-
12/1/2007 - Peer reviewed journal articlesThis paper discusses the results of a collaboration with a local drilling company to design and install a partial cab between the operator and the drill steel in an effort to reduce the sound level at the operator station of a surface drill rig.
-
11/1/2007 - Conference papersThis paper details laboratory noise testing results of a continuous mining machine conveyor system which uses a coating for the tail roller designed to help bring the continuous mining machine into compliance with federal noise regulations.
-
11/1/2007 - Peer reviewed journal articlesThis paper presents a method using a ray-tracing technique to determine absorption coefficients for underground mines. Absorption coefficients are determined and presented for octave bands from 63 Hz to 8 kHz.
-
10/1/2007 - Conference papersThis paper evaluates the duty cycle of a typical roof bolting machine operation at two coal mines. The results provide insight into which portion of the operators’ duty cycle is the most prominent contributor to noise exposure.
-
10/1/2007 - Conference papersThis paper provides a method for predicting sound pressure levels at the operator’s position of a roof bolting machine in an underground coal mine using sound power levels determined in the laboratory.
-
8/1/2007 - Technology NewsNIOSH, in partnership with stakeholders in the mining and surface drilling industries, conducted research to develop engineering controls to reduce workplace noise exposure. The result of this partnership is the development of a partial cab.
-
8/1/2007 - PC software, PresentationsPartial cab information suite containing instructions for building a cab to reduce sound levels by as much as 9 dB on surface air rotary drills.This can reduce the risk of noise-induced hearing loss.
-
5/1/2007 - Peer reviewed journal articlesThis paper summarizes a NIOSH investigation of engineering noise controls to reduce sound levels in cabs on air-rotary drill rigs. Results revealed that some drillers are exposed to A-weighted sound levels exceeding 85 dB even though a cab is used.
-
12/1/2006 - Conference papersA highly durable polyurethane coating has been developed for chain flights to decrease noise from metal-on-metal impacts. This paper evaluates this engineering noise control in reducing the noise exposure of continuous mining machine operators.
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program